Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
80
5-18 terminal speed
This command is used to setup the terminal speed. Use the no form of the command to reset to the
default setting.
terminal speed BPS
no terminal speed
Parameters
BPS
Specifies the console rate in bits per second (bps).
Default
By default, this value is 115200.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the terminal connection speed. Some baud rates available on the devices
connected to the port might not be supported on the Switch.
Example
This example shows how to configure the serial port baud rate to 9600 bps.
Switch# configure terminal
Switch(config)# terminal speed 9600
Switch(config)#
5-19 session timeout
This command is used to configure the line session timeout value. Use the no form of the command to
reset it to the default settings.
session-timeout MINUTES
no session-timeout
Parameters
MINUTES
Specifies the timeout length in minutes. 0 represents never timeout.
Default
By default, this value is 3 minutes.
Command Mode
Line Configuration Mode.
Command Default Level