Owners manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide

• The command login local tell the Switch that users need to enter locally configured login

credentials to access the console interface.

Save the running configuration to the start-up configuration. This means to save the changes made so

that when the Switch is rebooted, the configuration will not be lost. The following example shows how to

save the running configuration to the start-up configuration.

Switch#copy running-config startup-config

Destination filename startup-config? [y/n]: y

Saving all configurations to NV-RAM.......... Done.

Switch#

After the Switch was rebooted, or when the users logs out and back in, the newly created username and

password must be entered to access the CLI interface again, as seen below.

DGS-1510-28P Gigabit Ethernet SmartPro Switch

Command Line Interface

Firmware: Build 1.00.016

User Access Verification

Username:admin

Password:*****

Switch#

Interface Notation

When configuration the physical ports available on this switch, a specific interface notation is used. The

following will explain the layout, terminology and use of this notation.

In the following example, we’ll enter the Global Configuration Mode and then enter the Interface

Configuration Mode, using the notation 1/0/1. After entering the Interface Configuration Mode for port 1,

we’ll change the speed to 1 Gbps, using the speed 1000 command.

Switch# configure terminal

Switch(config)# interface Ethernet 1/0/1

Switch(config-if)# speed 1000

Switch(config-if)#

In the above example the notation 1/0/1 was used. The terminology for each parameter is as follows:

• Interface Unit’s ID / Open Slot’s ID / Port’s ID

The Interface Unit’s ID is the ID of the stacking unit without the physical stack. If stacking is disabled or

this unit is a stand-alone unit, then this parameter is irrelevant. The Open Slot’s ID is the ID of the module

plugged into the open module slot of the Switch. The DGS-1510 Series doesn’t support any open