Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
165
24
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
create arpentry <ipaddr> <macaddr>
config arpentry <ipaddr> <macaddr>
delete arpentry [<ipaddr> | all]
show arpentry {ipif system | ipaddress <ipaddr> | static}
config arp_aging time <value 1- 65535>
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose Used to make a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description This command is used to enter an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS3048#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS3048#