System information

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
25
From
States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch. Boot-up files are denoted by an asterisk (*) next to the file.
R – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Console Serial Port (RS-232).
T – If the IP address has this letter attached to it, it denotes a firmware upgrade through Telnet.
S – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Simple Network Management Protocol (SNMP).
W – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
web-based management interface.
SSH – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Secure Shell (SSH).
SIM – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Single IP Management feature.
User
States the user who downloaded the firmware. This field may read “Anonymous” or “Unknown”
for users that are not identified.
Power Saving Settings
This window allows the user to implement the Switch’s built-in power saving feature. When power saving is Enabled, a port
which has a link down status will be turned off to save power to the Switch. This will not effect the port’s capabilities when the
port status is link up.
To view the following window, click Configuration > Power Saving Settings:
Figure 2 - 29. Power Saving Settings window
The following parameter may be configured or viewed:
Parameter Description
Power Saving
State
Power savings is Enabled by default. To disable this feature, click the Disabled radio button.
Click Apply to set the password encryption.