System information

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
172
JWAC Port Settings
Users can configure JWAC port settings for the Switch.
To view the following window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Port Settings:
Figure 5 - 52. JWAC Port Settings window
To set the JWAC on individual ports for the Switch, complete the following fields:
Parameter Description
From Port
Use this drop-down menu to select the beginning port of a range of ports to be enabled as
JWAC ports.
To Port
Use this drop-down menu to select the ending port of a range of ports to be enabled as
JWAC ports.
Aging Time (1-1440)
This parameter specifies the time period during which an authenticated host will remain in the
authenticated state. Enter a value between 0 and 1440 minutes or tick the Infinite check box.
The default value is 1440. A value of 0 indicates the authenticated host will never age out on
the port.
MAC Authenticating
Host (1-10)
This parameter specifies the maximum number of host process authentication attempts
allowed on each port at the same time. The default value is 10. Enter a value between 1 and
10 attempts.
Idle Time (1-1440)
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. The default value is infinite. To change this value, first untick the
Infinite check box and then enter a value between 0 and 1440 minutes. A value of 0 indicates
the Idle state of the authenticated host on the port will never be checked.
Block Time (0-300)
This parameter is the period of time a host will be blocked if it fails to pass authentication.
Enter a value between 0 and 300 seconds. The default value is 0.
Mode
Toggle between Host Based and Port Based.
State
Use this drop-down menu to enable the configured ports as JWAC ports.
Click Apply to implement changes made.