Specifications

DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
config access_profile
Parameters
profile_id <value 1-8> An integer between 1 and 8 that is used to identify the access profile
that will be configured with this command.
type <value 0-65535> Specifies that the access profile will apply to this ICMP type value.
add access_id <value 1-255> Adds an additional rule to the above specified access profile.
The value specifies the relative priority of the additional rule. A lower access ID, the higher
the priority the rule will be given.
ethernet Specifies that the switch will look only into the layer 2 part of each packet.
vlan <vlan_name 32> Specifies that the access profile will apply to only to this VLAN.
source_mac <macaddr> Specifies that the access profile will apply to only packets with this
source MAC address.
destination_mac <macaddr> Specifies that the access profile will apply to only packets with
this destination MAC address.
802.1p <value 0-7> Specifies that the access profile will apply only to packets with this
802.1p priority value.
ethernet_type <hex 0x0-0xffff> Specifies that the access profile will apply only to packets
with this hexidecimal 802.1Q Ethernet type value in the packet header.
ip Specifies that the switch will look into the IP fields in each packet.
vlan <vlan_name 32> Specifies that the access profile will apply to only to this VLAN.
source_ip <ipaddr> Specifies that the access profile will apply to only packets with this
source IP address.
destination_id <value 0-255> Specifies that the access profile will apply to only packets
with this destination IP address.
dscp <value 0-63> Specifies that the access profile will apply only to packets that have this
value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet header.
icmp Specifies that the switch will examine the Internet Control Message Protocol (ICMP)
field within each packet.
code <value 0-255> Specifies that the access profile will apply to this ICMP code.
122