Specifications

DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
11
BROADCAST STORM CONTROL
COMMANDS
The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config traffic
control
<storm_portlist>
all
broadcast [enable|disable]
multicast [enable|disable]
dlf [enable|disable]
show traffic
control
port_list <storm_portlist>
Each command is listed, in detail, in the following sections.
config traffic control
Purpose
Used to configure broadcast|multicast traffic control.
Syntax config traffic control [<storm_portlist>|all] broadcast [enable|disable]|multicast
[enable|disable]|dlf [enable|disable]|threshold <value>
Description
This command is used to configure broadcast storm control.
Parameters
<storm_grouplist> − Used to specify a broadcast storm control group with the syntax:
module_id:group_id.
all − Specifies all broadcast storm control groups on the switch.
broadcast [enable|disable] − Enables or disables broadcast storm control.
multicast [enable|disable] − Enables or disables multicast storm control.
dlf [enable|disable] − Enables or disables dlf traffic control.
threshold <value> − The upper threshold at which the specified traffic control is switched on.
The <value> is the number of broadcast/multicast/dlf packets, in Kpps, received by the
switch that will trigger the storm traffic control measures.
Restrictions
Only administrator-level users can issue this command.
Example Usage:
To configure traffic control and state:
56