Specifications

DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
18
IP INTERFACE COMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif System vlan <vlan_name>
ipaddress <network_address>
state [enable|disable]
bootp
dhcp
show ipif <ipif_name>
Each command is listed, in detail, in the following sections.
config ipif System
Purpose
Used to configure the System IP interface.
Syntax config ipif System [{vlan <vlan_name>|ipaddress <network_address>|state
[enable|disable]|bootp|dhcp}]
Description
This command is used to configure the System IP interface on the switch.
Parameters
<vlan_name> − The name of the VLAN corresponding to the System IP interface.
<network_address> − IP address and netmask of th IP interface to be created. You can
specify the address and mask information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/16).
state [enable|disable] − Allows you to enable or disable the IP interface.
bootp − Allows the selection of the BOOTP protocol for the assignment of an IP address to
the switch’s System IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment of an IP address to the
switch’s System IP interface.
Restrictions
Only administrator-level users can issue this command.
Example Usage:
To configure the IP interface System:
88