User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
632
Chapter 63 Password Recovery
Commands
enable password_recovery
disable password_recovery
show password_recovery
63-1 enable password_recovery
Description
This command is used to enable the password recovery mode.
Note: The configuration does not take effect until saved.
Format
enable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the password recovery mode:
DGS-3420-28SC:admin# enable password_recovery
Command: enable password_recovery
Success.
DGS-3420-28SC:admin#
63-2 disable password_recovery
Description
This command is used to disable the password recovery mode.
Note: The configuration does not take effect until saved.