Systems Network Router User Manual

2. Use a CAT3 or CAT5 UTP Ethernet straight cable to connect the Local port to a free

port on your hub or switch OR Use a CAT 3 or CAT5 Cross-Over cable to connect

directly to a PC.

3. Connect the Power Adapter to the VDC IN port on the DI-701 and into a wall outlet.

4. Use an RS-232 cable to connect from a Serial port on the administrator computer to the

Console port on the DI-701. (Optional - for terminal program configuration only.)

SYSTEM ENVIRONMENT

Your system must meet the following requirements to use the DI-701 Setup Program. IF

you are using a Unix or Apple based system, telnet should be used to configure the DI-701:

Software Requirements

1. Microsoft Windows 95/98/NT installed.

2. Windows Graphic User Interface (GUI) setup program (provided) to configure through

Local Port; Or

Use a terminal emulation program such as Windows HyperTerminal to configure

through the Console Port.

Gather and write down the following information before beginning:

Factory Default Settings

The LAN parameters of the DI-701 are pre-set in the factory. The default values are shown

in Table 2: Local and Global Port Addresses.

Table 2: Local and Global Port Addresses

Local Port

Global Port

IP address

192.168.0.1

Subnet Mask

255.255.255.0

DHCP server function

Enabled

IP addresses for

distribution to PCs

32 IP addresses continuing

from 192.168.0.2 through

192.168.0.33

DHCP client function is

enabled to

automatically get the

Global port

configuration from ISP.