Systems Network Router User Manual

Configuring in GUI Mode

This section describes how to configure the DI-701 using the DI-701 Setup Software.

Getting Started (GUI)

1. Insert the included setup CD into your CD-ROM drive.

2. The CD will auto run, click on the “Install DI-701 Setup Software” icon.

3. Once the Setup Software has been installed, go to StartàProgramsàD-Link DI-701.

4. When the following dialog box appears, click Find.

Figure 4: DI-701 Setup Program

5. The setup program finds the DI-701. It will only find the DI-701 if (1) it is powered up

and (2) the Gateway for your computer is set to the IP address of the DI-701, and (3) the

DI-701 has completed its boot up process (30-60 seconds). Anytime changes are made

to the DI-701 and “Save” is pressed it will reboot, you must either reboot your client or

renew its IP address before finding the DI-701 if the DI-701 is set to pass out IP

addresses to its client computers.

6. Once the DI-701 is found, press “Configure”. The password dialog box may prompt

you to enter a password. The factory default is an empty password. Just leave the

password space blank. If you change the password please write it down somewhere

safe.

7. See the following sections for descriptions of the various settings.