Specifications

Using the Configuration Menu

Advanced > IP Filter

IP Filter-

Use IP Filters to deny LAN IP addresses access to the internet

Schedule-

IP Address-

Enter in the IP address range of the computers that you want the policy to apply to. If it

is only a single computer that you want the policy applied to, then enter the IP address of

that computer in the Start Source IP and leave the End Source IP blank.

Use IP (Internet Protocol)

filters to allow or deny

computers access to the

Internet based on their IP

address.

Port Range-

Enter in the port range of the TCP/UDP ports that you want the policy to apply to. If it is

only a single port that you want the policy applied to, then enter the port number in the

Start Port field and leave the End Port field blank. If you want to use all the ports, you

can leave the port range empty.

Enabled or Disabled-

Click Enabled to apply the filter policy or click Disabled to enter an inactive filter policy

(You can reactivate the policy later.)

Select Always, or choose From and enter the time period during which the IP filter policy

will be in effect.