User`s manual

11
Front Panel
The front panel provides LED’s for device status. Refer to the
following table for the meaning of each feature.
Power/Test Power status of the DI-804. The Power/Test LED will blink
once every two seconds to indicate proper operation. No LED
light indicates no power.
WAN
Link/Act
Wide Area Network status. When connected to the Internet,
the WAN LED should be on.
Ethernet
1 –4
Link/Act
Local Area Network port status. A steady LED indicates a
connection between computers on your LAN. A flickering
LED indicates data transmission.
Ethernet
1 –4
100Mbps
Speed status of the Ethernet connection. A steady LED
indicates 100Mbps speed. If the Link light in on and the
10/100 light is off, the speed is 10Mbps.
Rear Panel
The rear panel features a Power switch, an uplink port, LAN ports 1
through 4, WAN port and Factory Reset button. Refer to the following table
for the meaning of each feature.
Power Use this switch to provide power to your DI-804.
Uplink The Uplink port is used to connect your DI-804 to a switch or
hub using a straight-through Ethernet cable. Port 1 and the
Uplink port are the same port. Only one can be used at a time.
1 – 4 The RJ-45 Ethernet ports labeled 1 - 4 are used to connect your
computers using Ethernet cables to your DI-804.
WAN The RJ-45 Ethernet port labeled WAN is used to connect your
DI-804 to your DSL or Cable modem.
Factory
Reset
Resets the configuration to default settings. Refer to the
Appendix for instructions on how to perform a factory reset.