Specifications

22D-Link DIR-130 User Manual
Section 3 - Configuration
Select Static if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in the next
box.
Enter the ISP Service Name (optional).
Enter the IP address (Static PPPoE only).
The default MAC Address is set to the Internet port’s physical interface
MAC address on the Broadband Router. It is not recommended that you
change the default MAC address unless required by your ISP. You can
use the Clone MAC Address button to replace the Internet port’s MAC
address with the MAC address of your Ethernet card.
Enter a maximum idle time during which the Internet connection is
maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your specific ISP. 1492 is the default MTU.
Select either Always-on, On-Demand, or Manual.
In most cases, select Dynamic PPPoE. Select Static PPPoE if your ISP assigned you the IP address, subnet mask, gateway,
and DNS server addresses.
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
Address Mode:
User Name:
Password:
Service Name:
IP Address:
MAC Address:
Maximum Idle Time:
MTU:
Connect Mode:
WAN Physical
Setting:
DNS Addresses:
Internet Setup
Russian PPPoE (DSL)
Choose Russian PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer.
The software is no longer needed and will not work through a router.