User manual

Section 3 - Configuration
D-Link DSL-2740U User Manual
75
STATIC ROUTE
Enter the destination network address, subnet mask, gateway
AND/OR available WAN interface then click "Apply" to add the
entry to the routing table.
DEFAULT GATEWAY
If Enable Automatic Assigned Default Gateway checkbox is
selected, this router will accept the first received default gateway
assignment from one of the PPPoA, PPPoE or MER/DHCP
enabled PVC(s). If the checkbox is not selected, enter the static
default gateway AND/OR a WAN interface. Click "Apply" button
to save it.
RIP
To activate RIP for the device, select the 'Enabled' radio button
for Global RIP Mode. To configure an individual interface, select
the desired RIP version and operation, followed by placing a
check in the 'Enabled' checkbox for the interface. Click the 'Apply'
button to save the configuration, and to start or stop RIP based
on the Global RIP mode selected.