Setup guide

Example
[admin@Wandy] interface wireless align> print
frame-size: 300
active-mode: yes
receive-all: yes
audio-monitor: 00:00:00:00:00:00
filter-mac: 00:00:00:00:00:00
ssid-all: no
frames-per-second: 25
audio-min: 0
audio-max: 64
[admin@Wandy] interface wireless align>
Align Monitor
Command name: /interface wireless align monitor
Description
This command is used to monitor current signal parameters to/from a remote host.
Property Description
address (read-only: MAC address) - MAC address of the remote host
ssid (read-only: text) - service set identifier
rxq (read-only: integer) - signal strength of last received packet
avg-rxq (read-only: integer) - average signal strength of received packets since last display update
on screen
last-rx (read-only: time) - time in seconds before the last packet was received
txq (read-only: integer) - the last received signal strength from our host to the remote one
last-tx (read-only: time) - time in seconds when the last TXQ info was received
correct (read-only: percentage) - how many undamaged packets were received
Example
[admin@Wandy] interface wireless align> monitor wlan2
# ADDRESS SSID RXQ AVG-RXQ LAST-RX TXQ LAST-TX CORRECT
0 00:01:24:70:4B:FC wirelesa -60 -60 0.01 -67 0.01 100 %
[admin@Wandy] interface wireless align>
Network Scan
Description
This is a feature that allows you to scan all avaliable wireless networks. While scanning, the card
unregisters itself from the access point (in station mode), or unregisters all clients (in bridge or
ap-bridge mode). Thus, network connections are lost while scanning.