Setup guide

# INTERFACE BRIDGE

0 eoip-remote none

1 office-eth none

2 isp none

[admin@Our_GW] interface bridge> port set "0,1" bridge=bridge1

And the same for the Remote:

[admin@Remote] interface bridge> add forward-protocols=ip,arp,other \

\... disabled=no

[admin@Remote] interface bridge> print

Flags: X - disabled, R - running

0 R name="bridge1" mtu=1500 arp=enabled mac-address=00:00:00:00:00:00

forward-protocols=ip,arp,other priority=1

[admin@Remote] interface bridge> port print

Flags: X - disabled

# INTERFACE BRIDGE

0 ether none

1 adsl none

2 eoip-main none

[admin@Remote] interface bridge> port set "0,2" bridge=bridge1

4. Addresses from the same network can be used both in the Office LAN and in the Remote

LAN.

Troubleshooting

Description

• The routers can ping each other but EoIP tunnel does not seem to work!

Check the MAC addresses of the EoIP interfaces - they should not be the same!

Xpeed SDSL Interface

Document revision 1.1 (Fri Mar 05 08:18:04 GMT 2004)

This document applies to Wandy RouterOS V2.8

Table of Contents

General Information

Summary

Specifications