Setup guide

description connected to EthernetLAN
ip address 10.0.0.254 255.255.255.0
!
interface Serial0
description connected to Internet
no ip address
encapsulation frame-relay IETF
serial restart-delay 1
frame-relay lmi-type ansi
frame-relay intf-type dce
!
interface Serial0.1 point-to-point
ip address 1.1.1.2 255.255.255.0
no arp frame-relay
frame-relay interface-dlci 42
!
...
end.
Send ping to Wandy router
CISCO#ping 1.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 28/31/32 ms
CISCO#
Troubleshooting
Description
• I tried to connect two routers as shown in MT-to-MT, but nothing happens
The link indicators on both cards must be on. If it's not, check the cable or interface
configuration. One adapter should use LT mode and the other NT mode. You can also change
sdsl-swap and sdsl-invert parameters on the router running LT mode if you have a very long
line
ARLAN 655 Wireless Client Card
Document revision 1.1 (Fri Mar 05 08:12:25 GMT 2004)
This document applies to Wandy RouterOS V2.8
Table of Contents
Table of Contents
General Information
Summary