Setup guide

0 D RealTek 8139
1 Arlan 655 0xD000
[admin@Wandy] driver>
Wireless Interface Configuration
interface arlan
Description
The wireless card status can be obtained from the two LEDs: the Status LED and the Activity
LED.
Status Activity Description
Amber Amber
ARLAN 655 is functional but
nonvolatile memory is not
configured
Blinking Green Don't Care ARLAN 655 not registered to
an AP (ARLAN mode only)
Green Off Normal idle state
Green Green Flash Normal active state
Red Amber Hardware failure
Red Red Radio failure
Property Description
name (name; default: arlanN) - assigned interface name
mtu (integer; default: 1500) - Maximum Transmission Unit
mac-address (MAC address) - Media Access Control address
frequency (2412 | 2427 | 2442 | 2457 | 2465; default: 2412) - channel frequency in MHz
bitrate (1000 | 2000 | 354 | 500; default: 2000) - data rate in Kbit/s
sid (integer; default: 0x13816788) - System Identifier. Should be the same for all nodes on the
radio network. Must be an even number with maximum length 31 character
add-name (text; default: test) - card name (optional). Must contain less than 16 characters.
arp (disabled | enabled | proxy-arp | reply-only; default: enabled) - Address Resolution Protocol
setting
tma-mode (yes | no; default: no) - Networking Registration Mode:
• yes - ARLAN
• no - NON ARLAN
Example
[admin@Wandy] > interface print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE MTU
0 R outer ether 1500
1 X arlan1 arlan 1500
[admin@Wandy] interface> enable 1
[admin@Wandy] > interface print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE MTU