Setup guide

General Information
Summary
The Wandy RouterOS supports MOXA C101 Synchronous 4Mb/s Adapter hardware. The V.35
synchronous interface is the standard for VSAT and other satellite modems. However, you must
check with the satellite system supplier for the modem interface type.
Specifications
Packages required: synchronous
License required: level4
interface moxa-c101
Standards and Technologies: Cisco/HDLC-X.25 (RFC 1356), Frame Relay (RFC1490), PPP
(RFC-1661), PPP (RFC-1662)
Hardware usage: Not significant
Related Documents
• Package Management
• Device Driver List
• IP Addresses and ARP
• Log Management
Description
You can install up to four MOXA C101 synchronous cards in one PC box, if you have so many
slots and IRQs available. Assuming you have all necessary packages and licenses installed, in most
cases it should to be done nothing at that point (all drivers are loaded automatically). However, if
you have a non Plug-and-Play ISA card, the corresponding driver requires to be loaded.
MOXA C101 PCI variant cabling
The MOXA C101 PCI requires different from MOXA C101 ISA cable. It can be made using the
following table:
DB25f Signal Direction V.35m
4 RTS OUT C
5 CTS IN D
6 DSR IN E
7 GND - B
8 DCD IN F
10 TxDB OUT S
11 TxDA OUT P
12 RxDB IN T
13 RxDA IN R
14 TxCB IN AA
16 TxCA IN Y
20 DTR OUT H