Setup guide

22 RxCB IN X
23 RxCA IN V
short 9 and 25 pin
Additional Documents
For more information about the MOXA C101 synchronous 4Mb/s adapter hardware please see:
• http://www.moxa.com/product/sync/C101.htm - the product on-line documentation
• C101 SuperSync Board User's Manual the user's manual in PDF format
Synchronous Interface Configuration
interface moxa-c101
Description
Moxa c101 synchronous interface is shown under the interfaces list with the name moxa-c101-N
Property Description
name (name; default: moxa-c101-N) - interface name
cisco-hdlc-keepalive-interval (time; default: 10s) - keepalive period in seconds
clock-rate (integer; default: 64000) - speed of internal clock
clock-source (external | internal | tx-from-rx | tx-internal; default: external) - clock source
frame-relay-dce (yes | no; default: no) - operate or not in DCE mode
frame-relay-lmi-type (ansi | ccitt; default: ansi) - Frame-relay Local Management Interface type:
• ansi - set LMI type to ANSI-617d (also known as Annex A)
• ccitt - set LMI type to CCITT Q933a (also known as Annex A)
ignore-dcd (yes | no; default: no) - ignore or not DCD
line-protocol (cisco-hdlc | frame-relay | sync-ppp; default: sync-ppp) - line protocol name
mtu (integer; default: 1500) - Maximum Transmit Unit
Notes
If you purchased the MOXA C101 Synchronous card from Wandy, you have received a V.35
cable with it. This cable should work for all standard modems, which have V.35 connections. For
synchronous modems, which have a DB-25 connection, you should use a standard DB-25 cable.
The Wandy driver for the MOXA C101 Synchronous adapter allows you to unplug the V.35
cable from one modem and plug it into another modem with a different clock speed, and you do not
need to restart the interface or router.
Example
[admin@Wandy] interface> moxa-c101
[admin@Wandy] interface moxa-c101> print
Flags: X - disabled, R - running
0 R name="moxa-c101-1" mtu=1500 line-protocol=sync-ppp clock-rate=64000
clock-source=external frame-relay-lmi-type=ansi frame-relay-dce=no
cisco-hdlc-keepalive-interval=10s ignore-dcd=no
[admin@Wandy] interface moxa-c101>
You can monitor the status of the synchronous interface: