Setup guide

Connect a communication device, e.g., a baseband modem, to the V.35 port and turn it on. The
Wandy driver for the Cyclades Synchronous PCI Adapter allows you to unplug the V.35 cable
from one modem and plug it into another modem with a different clock speed, and you do not need
to restart the interface or router.
Property Description
name (name; default: cycladesN) - Maximum Transmission Unit
mtu (integer; default: 1500) - Maximum Transmission Unit
line-protocol (cisco-hdlc | frame-relay | sync-ppp; default: sync-ppp) - line protocol
media type (E1 | T1 | V24 | V35 | X21; default: V35) - the hardware media used for this interface
clock-rate (integer; default: 64000) - internal clock rate in bps
clock-source (internal | external | tx-internal; default: external) - source clock
line-code (AMI | B8ZS | HDB3 | NRZ; default: B8ZS) - for T1/E1 channels only. Line modulation
method:
• AMI - Alternate Mark Inversion
• B8ZS - Binary 8-Zero Substitution
• HDB3 - High Density Bipolar 3 Code (ITU-T)
• NRZ - Non-Return-To-Zero
framing mode (CRC4 | D4 | ESF | Non-CRC4 | Unframed; default: ESF) - for T1/E1 channels only.
The frame mode:
• CRC4 - Cyclic Redundancy Check 4-bit (E1 Signaling, Europe)
• D4 - Fourth Generation Channel Bank (48 Voice Channels on 2 T-1s or 1 T-1c)
• ESF - Extended Superframe Format
• Non-CRC4 - plain Cyclic Redundancy Check
• Unframed - do not check frame integrity
line-build-out (0dB | 7.5dB | 15dB | 22.5dB; default: 0) - for T1 channels only. Line Build Out
Signal Level.
rx-sensitivity (long-haul | short-haul; default: short-haul) - for T1/E1 channels only. Numbers of
active channels (up to 32 for E1 and up to 24 for T1)
chdlc-keepalive (time; default: 10s) - Cisco-HDLC keepalive interval in seconds
frame-relay-dce (yes | no; default: no) - specifies whether the device operates in Data
Communication Equipment mode. The value yes is suitable only for T1 models
frame-relay-lmi-type (ansi | ccitt; default: ansi) - Frame Relay Line Management Interface
Protocol type
Troubleshooting
Description
• The cyclades interface does not show up under the interfaces list
Obtain the required license for synchronous feature
• The synchronous link does not work
Check the V.35 cabling and the line between the modems. Read the modem manual