Setup guide

enable name command to enable the interface with a given name or number, for example:
[admin@Wandy] interface> print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-RATE MTU
0 X ether1 ether 0 0 1500
1 X ether2 ether 0 0 1500
[admin@Wandy] interface> enable 0
[admin@Wandy] interface> enable ether2
[admin@Wandy] interface> print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-RATE MTU
0 R ether1 ether 0 0 1500
1 R ether2 ether 0 0 1500
[admin@Wandy] interface>
The interface name can be changed to a more descriptive one by using /interface set command:
[admin@Wandy] interface> set 0 name=Local; set 1 name=Public
[admin@Wandy] interface> print
Flags: X - disabled, D - dynamic, R - running
# NAME TYPE RX-RATE TX-RATE MTU
0 R Local ether 0 0 1500
1 R Public ether 0 0 1500
[admin@Wandy] interface>
Use of the 'setup' Command
The initial setup of the router can be done by using the /setup command which enables an interface,
assigns an address/netmask to it, and configures the default route. If you do not use the setup
command, or need to modify/add the settings for addresses and routes, please follow the steps
described below.
Notes
The device drivers for NE2000 compatible ISA cards need to be loaded using the add command
under the /drivers menu. For example, to load the driver for a card with IO address 0x280 and IRQ
5, it is enough to issue the command:
[admin@Wandy] driver> add name=ne2k-isa io=0x280
[admin@Wandy] driver> print
Flags: I - invalid, D - dynamic
# DRIVER IRQ IO MEMORY ISDN-PROTOCOL
0 D RealTek 8139
1 D Intel EtherExpressPro
2 D PCI NE2000
3 ISA NE2000 280
4 Moxa C101 Synchronous C8000
[admin@Wandy] driver>
There are some other drivers that should be added manually. Please refer to the respective manual
sections for the detailed information on how drivers are to be loaded.
Basic Examples
Example
Assume you need to configure the Wandy router for the following network setup:
In the current example we use two networks: