Setup guide

PhoneJack Voice Ports
ip telephony voice-port phonejack
Property Description
name (name) - name given by the user or the default one
type (read-only: phonejack | phonejack-lite | phonejack-pci) - type of the card
autodial (integer; default: "") - phone number which will be dialed immediately after the handset
has been lifted. If this number is incomplete, then the remaining part has to be dialed on the
dial-pad. If the number is incorrect, busy tone is played. If the number is correct, then the
appropriate number is dialed
playback-volume (integer: -48..48; default: 0) - playback volume in dB
• 0 - 0dB meand no change to signal level
record-volume (integer: -48..48; default: 0) - record volume in dB
• 0 - 0dB meand no change to signal level
ring-cadence (text) - a 16-symbol ring cadence for the phone, each symbol lasts 0.5 seconds, +
means ringing, - means no ringing
region (name; default: us) - regional setting for the voice port. This setting is used for generating
the dial tones
aec (yes | no) - wheteher echo detection and cancellation is enabled
aec-tail-length (short | medium | long; default: short) - size of the buffer of echo detection
aec-nlp-threshold (off | low | medium | high; default: low) - level of cancellation of silent sounds
aec-attenuation-scaling (integer: 0..10; default: 4) - factor of additional echo attenuation
aec-attenuation-boost (integer: 0..90; default: 0) - level of additional echo attenuation
software-aec (yes | no) - software echo canceller (experimental, for most of the cards)
agc-on-playback (yes | no; default: no) - automatic gain control on playback (can not be used
together with hardware voice codecs)
agc-on-record (yes | no; default: no) - automatic gain control on record (can not be used together
with hardware voice codecs)
detect-cpt (yes | no; default: no) - automatically detect call progress tones
Command Description
clear-call - terminate a current call established with the specified voice port (name) - port name to
clear call with
show-stats - show voice port statistics (name) - port name show statistics of (time) - maximal time
of packet round trip (integer) - number of packets sent by this card (these packets are digitalized
input of the voice port) (integer) - number of bytes sent by this card (these packets are digitalized
input of the voice port) (text) - minimal/average/maximal intervals between packets sent (integer) -
number of packets received by this card (these packets form analog output of the voice port)
(integer) - number of bytes received by this card (these packets form analog output of the voice
port) (text) - minimal/average/maximal intervals between packets received (time) - approximate
delay time from the moment of receiving an audio packet from the IP network till it is played back
over the telephony voice port. The value shown is never less than 30ms, although the actual delay
time could be less. If the shown value is >40ms, then it is close (+/-1ms) to the actual delay time.
monitor - monitor status of the voice port (name) - port name to monitor (on-hook | off-hook | ring |
connection | busy) - current state of the port: