Setup guide

Command Description
clear-call - terminate a current call established with the specified voice port (name) - port name to
clear call with
show-stats - show voice port statistics (name) - port name show statistics of (time) - maximal time
of packet round trip (integer) - number of packets sent by this card (these packets are digitalized
input of the voice port) (integer) - number of bytes sent by this card (these packets are digitalized
input of the voice port) (text) - minimal/average/maximal intervals between packets sent (integer) -
number of packets received by this card (these packets form analog output of the voice port)
(integer) - number of bytes received by this card (these packets form analog output of the voice
port) (text) - minimal/average/maximal intervals between packets received (time) - approximate
delay time from the moment of receiving an audio packet from the IP network till it is played back
over the telephony voice port. The value shown is never less than 30ms, although the actual delay
time could be less. If the shown value is >40ms, then it is close (+/-1ms) to the actual delay time.
monitor - monitor status of the voice port (name) - port name to monitor (on-hook | off-hook | ring |
connection | busy) - current state of the port:
• on-hook - the handset is on-hook, no activity
• off-hook - the handset is off-hook, the number is being dialed
• ring - call in progress, direction of the call is shown by the direction property
• connection - the connection has been established
• busy - the connection has been terminated, the handset is still off-hook
(ip-to-port | port-to-ip) - direction of the call
• ip-to-port - call from the IP network to the voice card
• port-to-ip - call from the voice card to an IP address
(plugged | unplugged) - state of the PSTN line
• plugged - the telephone line is connected to the PSTN port of the card
• unplugged - there is no working line connected to the PSTN port of the card
(integer) - the phone number being dialed (text) - name and IP address of the remote party (name) -
CODEC used for the audio connection (time) - duration of the phone call
ISDN Voice Ports
ip telephony voice-port isdn
Property Description
name (name) - name given by the user or the default one
msn (integer) - telephone number of the ISDN voice port (ISDN MSN number)
lmsn (text) - msn pattern to listen on. It determines which calls from the ISDN line this voice port
should answer. If left empty, msn is used
autodial (integer; default: "") - phone number which will be dialed immediately on each incoming
ISDN call. If this number contains 'm', then it will be replaced by originally called (ISDN)
telephone number. If this number is incomplete, then the remaining part has to be dialed by the
caller. If the number is incorrect, call is refused. If the number is correct, then the appropriate
number is dialed. For that direct-call mode is used - the line is picked up only after the remote party
answers the call