Setup guide

• h323-call-type - call leg type (should be VoIP)
• h323-call-origin - indicates origin of call relatively to the gateway (answer for calls from IP
network, originate - to IP network)
• h323-setup-time - call setup time
• h323-conf-id - unique session ID
• h323-remote-address - the remote address of the session
• NAS-Port-Id - voice port ID
• Acct-Status-Type - record type (START when session is established; STOP when session is
closed; INTERIM-UPDATE (ALIVE)session is alive). The time between the interim-update
messages is defined by the interim-update-interval parameter (if it is set to 0s, there will be no
such messages)
The contents of the CDR (Call Detail Record) are as follows:
• • 0 - Local endpoint application cleared call
• 1 - Local endpoint did not accept call
• 2 - Local endpoint declined to answer call
• 3 - Remote endpoint application cleared call
• 4 - Remote endpoint refused call
• 5 - Remote endpoint did not answer in required time
• 6 - Remote endpoint stopped calling
• 7 - Transport error cleared call
• 8 - Transport connection failed to establish call
• 9 - Gatekeeper has cleared call
• 10 - Call failed as could not find user (in GK)
• 11 - Call failed as could not get enough bandwidth
• 12 - Could not find common capabilities
• 13 - Call was forwarded using FACILITY message
• 14 - Call failed a security check and was ended
• 15 - Local endpoint busy
• 16 - Local endpoint congested
• 17 - Remote endpoint busy
• 18 - Remote endpoint congested
• 19 - Could not reach the remote party
• 20 - The remote party is not running an endpoint
• 21 - The remote party host off line
• 22 - The remote failed temporarily app may retry
Property Description
use-radius-accounting (yes | no; default: no) - whether to use radius accounting or not
interim-update (integer; default: 0) - defines time interval between communications with the
router. If this time will exceed, RADIUS server will assume that this connection is down. This
value is suggested not to be less than 3 minutes
• 0 - no interim-update messages are sent at all
Notes
All the parameters, which names begin with h323, are CISCO vendor specific Radius attributes