Setup guide

voice-port=vctx1 prefix=1

• IP telephony gateway #2 should have

/ip telephony voice-port voip add name=gw1 remote-address=10.0.0.182 /ip telephony

numbers add dst-pattern=2.. voice-port=vctx1 prefix=1 add dst-pattern=1..

voice-port=gw1 prefix=2

The system works as follows:

To dial from the main office PBX#1 any extension of the remote office PBX#2, the extension with

the connected gateway at PBX#1 should be dialed first. Then, after the dial tone of the gateway#1 is

received, the remote extension number should be dialed.

To dial from the main office PBX#2 any extension of the remote office PBX#1, the actions are the

same as in first situation.

OSPF

Document revision 1.0 (Fri Mar 05 08:47:24 GMT 2004)

This document applies to Wandy RouterOS V2.8

Table of Contents

Summary

Specifications