Setup guide

Runtime Calibration
Command name: /system ups run-time-calibration
Description
The run-time-calibration command causes the UPS to start a run time calibration until less than
25% of full battery capacity is reached. This command calibrates the returned run time value.
Notes
The test begins only if the battery capacity is 100%.
Example
[Wandy] system ups> run-time-calibration
UPS Monitoring
Command name: /system ups monitor
Property Description
on-line (yes | no) - whether power is being provided by the external utility (power company)
on-battery (yes | no) - Whether UPS battery is supplying power
transfer-cause (text) - the reason for the most recent transfer to on-battery operation (only shown
when the unit is on-battery)
low-battery - only shown when the UPS reports this status
replace-battery - only shown when the UPS reports this status
overloaded-output - only shown when the UPS reports this status
smart-boost-mode - only shown when the UPS reports this status
smart-ssdd-mode - only shown when the UPS reports this status
run-time-calibration-running - only shown when the UPS reports this status
run-time-left (time) - the UPS's estimated remaining run time in minutes. You can query the UPS
when it is operating in the on-line, bypass, or on-battery modes of operation. The UPS's remaining
run time reply is based on available battery capacity and output load
battery-charge (percentage) - the UPS's remaining battery capacity as a percent of the fully
charged condition
battery-voltage - the UPS's present battery voltage. The typical accuracy of this measurement is
±5% of the maximum value (depending on the UPS's nominal battery voltage)
line-voltage - the in-line utility power voltage
output-voltage - the UPS's output voltage
load (percentage) - the UPS's output load as a percentage of full rated load in Watts. The typical
accuracy of this measurement is ±3% of the maximum of 105%
frequency (percentage) - when operating on-line, the UPS's internal operating frequency is
synchronized to the line within variations within 3 Hz of the nominal 50 or 60 Hz. The typical
accuracy of this measurement is ±1% of the full scale value of 63 Hz