Setup guide

led1 (yes | no; default: no) - whether the LED1 is on
led2 (yes | no; default: no) - whether the LED2 is on
led3 (yes | no; default: no) - whether the LED3 is on
led4 (yes | no; default: no) - whether the LED3 is on
length (time; default: 0s) - how long to hold the given combination
• 0s - no limit
Notes
The command does not imply a pause in execution. It works asynchronously, allowing execution to
continue just after the command was entered, not waiting for LEDs to switch off.
After the given time (length property) the LEDs will return to the default (off) condition.
Any new :led command overrides the the previous state and resets the LED state after the length
time interval.
Example
To turn LED1 on for a minute:
[admin@Wandy] > :led led1=yes length=1m
[admin@Wandy] >
Console Reset Jumper
Description
The J16 jumper on the RouterBOARD may be used as serial console reset pin. If it held short for at
least 10 seconds, then:
• Serial console configuration is reset
• Serial port that serial console will pick by default (usually serial0) is set to 9600 baud 8 bit 1
stop bit no parity (default settings after installation)
• Special flag that prevents any other program except serial console to acquire this port is set
• Router is rebooted
License Management
Document revision 2.9 (Tue Mar 30 17:43:21 GMT 2004)
This document applies to Wandy RouterOS V2.8