Setup guide

io (integer) - input-output port base address
irq (integer) - interrupt request number
isdn-protocol (euro | german; default: euro) - line protocol setting for ISDN cards
memory (integer; default: 0) - shared memory base address
name (name) - driver name
Notes
Not all combinatios of irq and io base addresses might work on your particular system. It is
recommended, that you first find an acceptable irq setting and then try different i/o base addresses.
If you need to specify hexadecimal values instead of decimal for the argument values, put 0x before
the number.
To see the list of available drivers, issue the /driver add name ? command.
The resource list shows only those interfaces, which are enabled.
Typical io values for ISA cards are 0x280, 0x300 and 0x320
Example
To view the list of available drivers, do the following:
[admin@Wandy] driver> add name ?
3c509 c101 lance ne2k-isa pc-isa
[admin@Wandy] driver> add name
To see system resources occupied by the devices, use the /system resource io print and /system
resource irq print commands:
[admin@Wandy] system resource> io print
PORT-RANGE OWNER
0x20-0x3F APIC
0x40-0x5F timer
0x60-0x6F keyboard
0x80-0x8F DMA
0xA0-0xBF APIC
0xC0-0xDF DMA
0xF0-0xFF FPU
0x100-0x13F [prism2_cs]
0x180-0x1BF [orinoco_cs]
0x1F0-0x1F7 IDE 1
0x3D4-0x3D5 [cga]
0x3F6-0x3F6 IDE 1
0x3F8-0x3FF serial port
0xCF8-0xCFF [PCI conf1]
0x1000-0x10FF [National Semiconductor Corporation DP83815 (MacPhyter) Et...
0x1000-0x10FF ether1
0x1400-0x14FF [National Semiconductor Corporation DP83815 (MacPhyter) Et...
0x1400-0x14FF ether2
0x1800-0x18FF [PCI device 100b:0511 (National Semiconductor Corporation)]
0x1C00-0x1C3F [PCI device 100b:0510 (National Semiconductor Corporation)]
0x1C40-0x1C7F [PCI device 100b:0510 (National Semiconductor Corporation)]
0x1C80-0x1CBF [PCI device 100b:0515 (National Semiconductor Corporation)]
0x1CC0-0x1CCF [National Semiconductor Corporation SCx200 IDE]
0x4000-0x40FF [PCI CardBus #01]
0x4400-0x44FF [PCI CardBus #01]
0x4800-0x48FF [PCI CardBus #05]
0x4C00-0x4CFF [PCI CardBus #05]
[admin@Wandy] system resource> irq print
Flags: U - unused
IRQ OWNER
1 keyboard