Setup guide

Related Documents
• Package Management
• Device Driver List
• IP Addresses and ARP
• Log Management
Additional Documents
• http://www.ietf.org/rfc/rfc1853.txt?number=1853
• http://www.ietf.org/rfc/rfc2003.txt?number=2003
• http://www.ietf.org/rfc/rfc1241.txt?number=1241
IPIP Setup
interface ipip
Description
An IPIP interface should be configured on two routers that have the possibility for an IP level
connection and are RFC 2003 compliant. The IPIP tunnel may run over any connection that
transports IP. Each IPIP tunnel interface can connect with one remote router that has a
corresponding interface configured. An unlimited number of IPIP tunnels may be added to the
router. For more details on IPIP tunnels, see RFC 2003.
Property Description
name (name; default: ipipN) - interface name for reference
mtu (integer; default: 1480) - Maximum Transmission Unit. Should be set to 1480 bytes to avoid
fragmentation of packets. May be set to 1500 bytes if mtu path discovery is not working properly
on links
local-address (IP address) - local address on router which sends IPIP traffic to the remote host
remote-address (IP address) - the IP address of the remote host of the IPIP tunnel - may be any
RFC 2003 compliant router
Notes
Use /ip address add command to assign an IP address to the IPIP interface.
There is no authentication or 'state' for this interface. The bandwidth usage of the interface may be
monitored with the monitor feature from the interface menu.
Wandy RouterOS IPIP implementation has been tested with Cisco 1005. The sample of the Cisco
1005 configuration is given below:
interface Tunnel0
ip address 10.3.0.1 255.255.255.0
tunnel source 10.0.0.171
tunnel destination 10.0.0.204
tunnel mode ipip