Setup guide

• unknown - the connection is not recognized

rate (10 Mbps | 100 Mbps | 1000 Mbps) - the actual data rate of the connection

auto-negotiation (done | incomplete) - fast link pulses (FLP) to the adjacent link station to

negotiate the SPEED and MODE of the link

• done - negotiation done

• incomplete - negotiation failed

full-duplex (yes | no) - whether transmission of data occurs in two directions simultaneously

Notes

See the IP Addresses and ARP section of the manual for information how to add IP addresses to

the interfaces.

Example

[admin@Wandy] interface ethernet> monitor ether1,ether2

status: link-ok link-ok

auto-negotiation: done done

rate: 100Mbps 100Mbps

full-duplex: yes yes

Troubleshooting

Description

• Interface monitor shows wrong information

In some very rare cases it is possible that the device driver does not show correct information,

but it does not affect the NIC's performance (of course, if your card is not broken)

MOXA C502 Dual-port Synchronous Interface

Document revision 1.1 (Fri Mar 05 08:16:21 GMT 2004)

This document applies to Wandy RouterOS V2.8

Table of Contents

General Information

Summary

Specifications