CDMA 2000 EVDO Rev.
Quick Installation Guide DWM-162 CDMA 2000 EVDO Rev. A USB Dongle About D-Link DWM-162 DWM-162 is a CDMA EVDO Rev.A USB Dongle. Besides Windows OS, DWM-162 can also be run under MAC environment which makes it become the perfect solution for customization. DWM-162 can support the downlink up to 3.1 Mbps and uplink up to 1.8Mbps. Hardware Installation UIM Card Installation Steps: 1. Ensure the USB modem is plug off. Remove the back cover. 2.
Software Installation Before you install the software, you must first install a UIM card into the USB modem and connect the modem to a USB port on your computer. 1. Step 1: The first time you plug in the dongle to your computer, the dongle will run the installation application automatically. 2. Step 2: Please follow the intallation by clicking “Next”, the application will install the driver and the connection manager to your computer automatically. 3.
Troubleshooting 1. Connect the USB modem on the computer, Connection Manager can not install Automatically. Please enter the virtual CD ROM in explorer, then click Autorun.exe. 2. Connect the USB modem on the computer, the modem can not work. Please check the UIM card is installed property. Make sure your UIM card do have 3G data service. Or check if the Antivirus Software block the connection. Technical Support: Thank you for choosing D-Link products.
FCC statement : Se ction 15.105 (b) Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
