2. Set both hubs for 10 Bps, 3. Make sure jack 4 on hub A is unused. ons are bade, s jack must remain unused after al 4. Plug one end of a suitable cable into hub A's Ui ok jack. the sae kind of cable as you would use for 4 ABASE-T end node. 5. Plug the other end of the cable into any jack except the Up kink jack on bub but Eave jack 4 on hub A and the Up link jack on hub B mused.
Jacks 1, 2, 3, and 4 are RI-45 connectors for the hub's network ports, Each is wired to work with a cable from a network end node or from another huts up link jack. The Up link jack is an ROJAS jack wired for an up link connection to anther hub. This jack is part of the same circuit as jack 4: never use both of these jacks at the same time. Technical Note: The difference between the Up link jack and jack 4 is that the transmit and receive lines are crossed in jack 4 and uncrossed in the Up link jack.
Open the shipping carton of your hub and carefully unpack the contents. The carton should contain the following items: + One dual-sped hub ยข One AC power adapter. suitable for your area electrical power canonizations + Mounting accessories (rubber ghost, screws, aud Walt anchors) + This User's Guide Inspect the hub and alt accompanying items.
CONTENTS Introduction Product Description... Unpacking and Setup .. Identifying External Components Front Pane) Side Panels Back Panel, Installing the Hub... Single-hub Network . Multi-hub Ethernet Network TWA-hub Past Ethernet Network . MOunting...omnconessnsccsenacs Horizontal Mounting Vertical Mounting Powering Up vn. TRANSPOSITIONS crrvrorserresressserreen Introduction This guide explains how to sel up and use the D-Link DEF-904 Togetherness Ethernet mini-hub.
