User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration (Router Mode)
- Web-based Configuration Utility
- Setup
- IPv6
- IPv6 Manual Setup
- PLC Settings (Router Mode)
- Advanced
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Tools
- Status
- Wireless Connection Setup Wizard
- Wireless Security Setup Wizard
- Add Wireless Device with WPS Wizard
- Configuration (AP Mode)
- Web-based Configuration Utility
- Wireless Setup Wizard
- Configuration
- Status
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
118D-Link DHP-1565 User Manual
Section 3 - Conguration
Advanced Wireless
Transmit
Power:
WLAN
Partition:
WMM Enable:
Short GI:
Sets the transmit power of the antennas.
Note: Transmit power is regulated by international
standard. Users are forbidden to change its maximum limit.
Select this checkbox to enable WLAN partition. If this
feature is enabled, then there is no barrier between
communication among wireless stations connecting to
the Access Point. If this is disabled, wireless clients are not
allowed to exchange data through the Access Point.
WMM is a Quality of Service (QoS) system for your wireless network. Enabling this feature will improve the quality of video and ice
applications for your wireless clients.
Check this box to reduce the guard interval time therefore increasing the data capacity. However, this setting less reliable and may
create higher data loss.