User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration (Router Mode)
- Web-based Configuration Utility
- Setup
- IPv6
- IPv6 Manual Setup
- PLC Settings (Router Mode)
- Advanced
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Tools
- Status
- Wireless Connection Setup Wizard
- Wireless Security Setup Wizard
- Add Wireless Device with WPS Wizard
- Configuration (AP Mode)
- Web-based Configuration Utility
- Wireless Setup Wizard
- Configuration
- Status
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
15D-Link DHP-1565 User Manual
Section 1 - Product Overview
PowerLine Security
It is strongly recommended to encrypt your PowerLine network. By encrypting the data that is sent via your PowerLine adapters, you will prevent
nearby hackers with a Powerline adapter to connect to your network and steal your information.
To encrypt your PowerLine network, follow the steps below:
PowerLine Network-Quick Setup
The Simple Connect Button is used to add a PowerLine AV device to a PowerLine network. You can allow the DHP-1565 to join a network by pressing
the Simple Connect Button to toggle it to the Broadcast state or Join state.
The Simple Connect Button has 3 dierent trigger states:
Broadcast state- Enables the DHP-1565 to provide information for another PowerLine AV device to join its PowerLine network (works
even if it is the only device existing within the network group). The rst PowerLine device will use this state when the Simple Connect
Button is pressed.
Join State - This allows an ungrouped PowerLine AV device to join an existing PowerLine network. PowerLine devices added after
the rst device will be in the Join State when the Simple Connect Button is pressed.
Ungroup State - Hold down the Simple Connect Button for more than 10 seconds to detach the device from its network group.
Encryption Button Usage