User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration (Router Mode)
- Web-based Configuration Utility
- Setup
- IPv6
- IPv6 Manual Setup
- PLC Settings (Router Mode)
- Advanced
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Tools
- Status
- Wireless Connection Setup Wizard
- Wireless Security Setup Wizard
- Add Wireless Device with WPS Wizard
- Configuration (AP Mode)
- Web-based Configuration Utility
- Wireless Setup Wizard
- Configuration
- Status
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
33D-Link DHP-1565 User Manual
Section 3 - Conguration
Select Static if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases,
select Dynamic.
Enter the L2TP IP address supplied by your ISP (Static only).
Enter the Subnet Mask supplied by your ISP (Static only).
Enter the Gateway IP Address provided by your ISP.
Enter the Server IP provided by your ISP (optional).
Enter your L2TP username.
Enter your L2TP password and then retype the password in
the next box.
Use the radio buttons to specify the reconnect mode. The user
can specify a custom schedule or specify the On Demand, or
Manual option.
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
Address Mode:
L2TP IP Address:
L2TP Subnet
Mask:
Manual Internet Connection Setup
L2TP
Choose L2TP (Layer 2 Tunneling Protocol) if your ISP uses a L2TP connection. Your ISP will provide you with a username and password. This option
is typically used for DSL services.
L2TP Gateway
IP Address:
L2TP Server IP
Address:
Username:
Password:
Reconnect
Mode:
Maximum Idle
Time: