User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Quick Router Setup Wizard (CD)
- Quick Setup Wizard
- Web-based Configuration Utility
- Manual Internet Setup
- Manual Configuration
- Wireless Security
- Configure WEP
- Configure WPA/WPA2 Personal
- Configure WPA Enterprise
- Advanced
- Maintance
- Status
- Quick Setup Wizard
- Manual Configuration
- Wireless Security
- Configure WEP
- Configure WPA/WPA2 Personal
- Advanced
- Wi-Fi Protected Setup
- Maintenance
- Status
- Quick Setup Wizard
- Setup
- Configure WPA/WPA2 Personal
- Advanced
- Maintance
- Status
- Help
- Connect a Wireless Client to your Router
- Troubleshooting
- Wireless Basics
- Networking Basics
- Contacting Technical Support
- GPL Code Statement
- Warranty
- Registration
13D-Link DIR-505 User Manual
Section 2 - Installation
4. Plug one end of the included blue Ethernet cable that came with your router into the yellow port labeled
INTERNET on the back of the router. Plug the other end of this cable into the Ethernet port on your modem.
5. Reconnect the power adapter to your cable or DSL broadband modem and wait for two minutes.
6. Connect the supplied power adapter into the power port on the back of the router and then plug it into a power
outlet or surge protector. Press the power button and verify that the power LED is lit. Allow 1 minute for the
router to boot up.
7. If you are connecting to a Broadband service that uses a dynamic connection (not PPPoE), you may be online
already. Try opening a web browser and enter a web site. If you connect, you are nished with your Internet setup.
Please skip to page 13 to congure your router and use the manual setup procedure to congure your network
and wireless settings. If you did not connect to the Internet, use the D-Link Setup Wizard (refer to page 15).