User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Quick Router Setup Wizard (CD)
- Quick Setup Wizard
- Web-based Configuration Utility
- Manual Internet Setup
- Manual Configuration
- Wireless Security
- Configure WEP
- Configure WPA/WPA2 Personal
- Configure WPA Enterprise
- Advanced
- Maintance
- Status
- Quick Setup Wizard
- Manual Configuration
- Wireless Security
- Configure WEP
- Configure WPA/WPA2 Personal
- Advanced
- Wi-Fi Protected Setup
- Maintenance
- Status
- Quick Setup Wizard
- Setup
- Configure WPA/WPA2 Personal
- Advanced
- Maintance
- Status
- Help
- Connect a Wireless Client to your Router
- Troubleshooting
- Wireless Basics
- Networking Basics
- Contacting Technical Support
- GPL Code Statement
- Warranty
- Registration
36D-Link DIR-505 User Manual
Section 4 - Security
Congure WEP
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based conguration by opening a web browser and entering the IP address of the router (192.168.0.1).
Click on Wireless Setup on the left side.
2. In the Security Mode section, select WEP from the drop-down
menu.
3. In WEP Key Length, select either 64Bit or 128Bit encryption from
the drop-down menu.
5. Next to WEP Key 1, enter a WEP key that you create. Make sure
you enter this key exactly on all your wireless devices. You may
enter up to four dierent keys either using Hex or ASCII. Hex is
recommended (letters A-F and numbers 0-9 are valid). In ASCII all
numbers and letters are valid.
6. Click Save Settings to save your settings. If you are conguring
the router with a wireless adapter, you will lose connectivity until
you enable WEP on your adapter and enter the same WEP key as
you did on the router.