User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Quick Router Setup Wizard (CD)
- Quick Setup Wizard
- Web-based Configuration Utility
- Manual Internet Setup
- Manual Configuration
- Wireless Security
- Configure WEP
- Configure WPA/WPA2 Personal
- Configure WPA Enterprise
- Advanced
- Maintance
- Status
- Quick Setup Wizard
- Manual Configuration
- Wireless Security
- Configure WEP
- Configure WPA/WPA2 Personal
- Advanced
- Wi-Fi Protected Setup
- Maintenance
- Status
- Quick Setup Wizard
- Setup
- Configure WPA/WPA2 Personal
- Advanced
- Maintance
- Status
- Help
- Connect a Wireless Client to your Router
- Troubleshooting
- Wireless Basics
- Networking Basics
- Contacting Technical Support
- GPL Code Statement
- Warranty
- Registration
37D-Link DIR-505 User Manual
Section 4 - Security
Congure WPA/WPA2 Personal
It is recommended to enable encryption on your wireless access
point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless
signal may degrade when enabling encryption due to the added
overhead.
1. Log into the web-based conguration by opening a web browser
and entering the IP address of the access point (192.168.0.50).
Click on Setup and then click Wireless Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to Cipher Type, select TKIP, AES, or Auto.
4. Next to Passphrase, enter a key. The key is entered as a passphrase
in ASCII format at both ends of the wireless connection. The
passphrase must be between 8-63 characters.
6. Click Save Settings at the top of the window to save your settings.
If you are conguring the access point with a wireless adapter, you will lose connectivity until you enable WPA-PSK on your
adapter and enter the same passphrase as you did on the access point.