User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Desktop Computer
- DIR-601 Router
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard
- Manual Configuration
- Wireless Settings
- Network Settings
- IPv6
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Routing
- Advanced Wireless Settings
- Advanced Network Settings
- IPv6 Routing
- Administrator Settings
- Time Settings
- SysLog
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Stats
- Internet Sessions
- Routing Table
- Wireless
- IPv6
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
22D-Link DIR-601 User Manual
Section 3 - Conguration
Select either Always-on, On-Demand, or Manual.
Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable
Auto-reconnect.
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specic ISP. 1492 is the default
MTU.
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can use the Clone Your PC’s MAC Address button to
replace the Internet port’s MAC address with the MAC address of your Ethernet card.
Reconnection
Mode:
Maximum Idle
Time:
DNS Addresses:
MTU:
MAC Address: