User's Manual

56D-Link DIR-610 User Manual
Section 3 - Software Conguration
The following parameters will be available for conguration:
Enable DHCP-
PD:
Select this option to enable DHCP PD.
LAN IPv6
Address:
Enter the LAN IPv6 address used here. This address
must be in the ‘/64’ subnet.
LAN IPv6 Link-
Local Address:
Displays the LAN IPv6 Link-Local address used
here.
The following parameters will be available for conguration:
Enable Automatic
IPv6 address:
The user can tick this option to enable the auto-
conguration feature.
Enable Automatic
DHCP-PD in LAN:
Tick this option to enable the automatic DHCP-
PD on the LAN.
Autoconguration
Type:
The user can select the auto-conguration type
used here.
Router
Advertisement
Lifetime:
This option is only available when the auto-
conguration type is set to Stateless. Enter the
router advertisement lifetime value used here.
IPv6 Address
Range (Start):
This option is only available when the auto-
conguration type is set to Stateful. Enter the
start IPv6 Address for the DHCPv6 range for your
local computers.
IPv6 Address
Range (End):
This option is only available when the auto-
conguration type is set to Stateful. Enter the
end IPv6 Address for the DHCPv6 range for your
local computers.
IPv6 Address
Lifetime:
This option is only available when the auto-
conguration type is set to Stateful. Enter the
IPv6 Address Lifetime (in minutes).
Click on the Save Settings button to accept the changes made.
Click on the Don’t Save Settings button to discard the changes made.