User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Setup Wizard
- Manual Configuration
- Internet Setup
- Wireless Settings
- Network Settings
- Media Server
- IPv6 Internet Connection
- IPv6 Manual Setup
- Auto Detection
- Static IPv6 (Stateful)
- Static IPv6 (Stateless)
- Autoconfiguration (Stateful)
- Autoconfiguration (Stateless)
- PPPoE (Stateful)
- PPPoE (Stateless)
- IPv6 in IPv4 Tunneling (Stateful)
- IPv6 in IPv4 Tunneling (Stateless)
- 6 to 4 Tunneling (Stateful)
- 6 to 4 Tunneling (Stateless)
- 6rd (Stateless)
- 6rd (Stateful)
- Link-Local Connectivity
- Parental Controls
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Application Level Gateway Configuration
- Routing
- Advanced Wireless Settings
- WISH Settings
- Wi-Fi Protected Setup (WPS)
- Advanced Network Settings
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Administrator Settings
- Time Settings
- SysLog
- Email Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Stats
- Active Sessions
- Wireless
- IPv6
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
60D-Link DIR-657 User Manual
Section 3 - Conguration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to synchronize
a wireless network. Specify a value. 100 is the default setting
and is recommended.
This value should remain at its default setting of 2432. If
inconsistent data ow is a problem, only a minor modication
should be made.
The fragmentation threshold, which is specied in bytes,
determines whether packets will be fragmented. Packets
exceeding the 2346 byte setting will be fragmented before
transmission. 2346 is the default setting.
(Delivery Trac Indication Message) 3 is the default setting.
A DTIM is a countdown informing clients of the next window
for listening to broadcast and multicast messages.
WMM is QoS for your wireless network. This will improve
the quality of video and voice applications for your wireless
clients.
Check this box to reduce the guard interval time therefore
increasing the data capacity. However, it’s less reliable and
may create higher data loss.
Transmit Power:
Beacon Period:
RTS Threshold:
Fragmentation
Threshold:
DTIM Interval:
WMM Function:
Short GI:
Advanced Wireless Settings