DSH-G300 D-Link Corporation DSH-G300 Smart Hub Manual Version 1.
DSH-G300 D-Link Corporation Table of Contents 1. 2. 3. PRODUCT DESCRIPTION .................................................................................. 3 APPEARANCE ..................................................................................................... 3 INSTALLATIONS & CONFIGURATIONS .......................................................
DSH-G300 D-Link Corporation 1. PRODUCT DESCRIPTION The DSH-G300 is a ZigBee to Ethernet gateway device that uses a generic hardware design and can be deployed as different versions to fulfil different applications. 2. APPEARANCE Top LED: Status indicator Wireless button: pairing/un-pairing Rear LAN port Micro USB: Power jack, Vdc USB port Bottom Reset button : 5V/2.
DSH-G300 D-Link Corporation Mounting installation 3. INSTALLATIONS & CONFIGURATIONS how to build firmware by GPL Install tools Install fedora linux 22, and make sure you can connect to internet.
DSH-G300 D-Link Corporation no guarantee of a successful build.) Setup Build Enviornment($means command) 1) please login as a normal user such as john, and copy the gpl file to normal user folder, such as the folder /home/john 2) $cd /home/john 3) $tar zxvf DSHG300_A1_GPLv100b01.tar.
DSH-G300 D-Link Corporation 4) After make successfully, you will find the image file in ./images/. Tips: If there are some options need to be selected, please input "enter" key to execute the default action. How to install file into firmware Copy file into rootfs then rebuild gpl firmware by “make release”. $cd DSHG300_A1_GPLv100b01 $cp ~/test_lib rootfs/lib $make release Tips: If there is not rootfs, please using full steps to build firmware firstly.
DSH-G300 D-Link Corporation firstly. Run kernel menuconfig and select jffs2 option, then save it. $ cd DSHG300_A1_GPLv100b01/kernels/MT7688_linux-2.6.36.
DSH-G300 D-Link Corporation mount mtd partition After firmware upgrade, show all mtd partitions by below command: $ cat proc/mtd For this example, “data” mtd partition is mtd6 , it’s means that dev path of “data” mtd partition is /dev/mtdblock/6. Use below command to mount mtd partition “test” with jffs2 type. $ mount -t jffs2 /dev/mtdblock/6 /data Tips1: mtd partition must larger than 320k.
DSH-G300 D-Link Corporation Default password is null(“”). Enter firmware upgrade page. Select firmware file and press Upload button.
DSH-G300 D-Link Corporation How to use telnet and tftp How to use telnet Telnet is enable as default,use tool to access it. Example is Microsoft cmd tool. Device default ip is 192.168.0.50. How to use tftp Tftp can transfer a file from/to tftp server. This is an exanple(tftp server ip is 192.168.0.38). $ #get file from tftp server $ tftp -r get_file.txt -l get_file.txt -g 192.168.0.38 $ #put file from tftp server $ tftp -r put_file.txt -l put _file.txt -g 192.168.0.
DSH-G300 D-Link Corporation Console define Console connection type is Serial and speed is 57600 Page 11
DSH-G300 D-Link Corporation FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication.
