DSL-6300V USER MANUAL FEBRUARY 2011 ISSUE 1
All other trademarks are the property of their respective owners.. The information presented is subject to change without notice. D-Link Corporation assumes no responsibility for inaccuracies contained herein. Copyright © 2011 D-Link Corporation. All Rights Reserved. Conformance statements The device complies with Part 68 of the Federal Communications Commission (FCC) statements and UL.
Contents About this document Purpose ......................................................................................................................................................... v Reason for revision ....................................................................................................................................... v Intended audience .........................................................................................................................................
............................................................................................................................................................................................................................................................ ............................................................................................................................................................................................................................................................
About this document Purpose The purpose of the User Manual is to provide installation information, procedures for installation, service activation and system reconfiguration for the DSL-6300V VDSL2 Bridge. Additionally the User Manual contains status indicators and troubleshooting information and a comprehensive description of safety guidelines. Reason for revision This version 1.0 of the User Manual is the first issue.
About this document ............................................................................................................................................................................................................................................................ • • • • • Do not insert any sharp object into the products module openings or empty slots. Doing so may accidentally damage its parts. Do not attach the power supply cable on building surfaces or floorings.
1 Installation Guide Overview Purpose This Installation Guide provides information about how to install the DSL-6300V VDSL2 Bridge at the customers premises, which may be apartment blocks, hotels or office complexes. This customer premises equipment (CPE) supports Ethernet-over-VDSL2 via one Ethernet data link rated up to 100 Mbps symmetrically.
Installation Guide Install the CPE ............................................................................................................................................................................................................................................................ Figure 1-1 Overview about all external connections System requirements and safety guidelines 1. The CPE should be located in a cool dry place, with at least 5 cm (2 in.) of space on all sides for ventilation.
Installation Guide Install the CPE ............................................................................................................................................................................................................................................................ Mounting procedure There are two ways for mounting the CPE: • Wall mounting 1. Locate a high position on the wall that is free of obstructions. 2. Connect two screws in the wall 5 cm (2 in.) apart.
Installation Guide Install the CPE ............................................................................................................................................................................................................................................................ ........................................................................................................................................................................................................................
A Troubleshooting Overview Purpose This Appendix provides guidance for troubleshooting. The CPE operation can easily be monitored via the LED indicators to identify problems. The table below describes common problems you may encounter and possible solutions. Diagnosing Symptom Possible cause Solution POWER LED does not light up after power on. Power outlet, power cord, or power adapter may be defective. • VDSL is flashing slowly after making a connection.
Troubleshooting Overview ............................................................................................................................................................................................................................................................ .......................................................................................................................................................................................................................................
B TCP/IP configuration Overview The following procedures provide TCP/IP configuration instructions for all supported operating systems. Windows 7 1. 2. 3. 4. 5. 6. 7. Open Network and Internet from the Control Panel. Open Network and Sharing Center from the Network and Internet. Right-click Local Area Connection from Network and Sharing Center. Under the General tab, select Internet Protocol (TCP/IPv4), and click Properties. Select the Obtain an IP address automatically radio button.
TCP/IP configuration Overview ............................................................................................................................................................................................................................................................ 3. Under the General tab, select Internet Protocol (TCP/IP), and click Properties. The Internet Protocol (TCP/IP) properties window appears. 4. Select the Obtain an IP address automatically radio button. 5.
C Product conformance Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Product conformance ............................................................................................................................................................................................................................................................ FCC Part 68 Statement This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA.
