User Manual Part 2

D-Link Smart WLAN Manager User Manual
D-Link Corporation 35
AP Status and Trouble Shooting
Status
List
view
Tree
view
Topology
view
Description/Trouble shooting Remark
Normal online AP
An AP links and works properly in the network.
Changed AP
A known AP which configuration has been changed.
You can reload the original setting or save the current setting by:
1. Reload: double click to Reload old configuration, or
2. Save: press the save current
New AP
A new AP was discovered by WLAN Manager.
Offline AP
An existing AP lost the connection
1. Check the status of the connected switch and ensure the switch is
online
2. Cold start the AP from the switch webpage
3. Cold start the AP detached the wire reconnected to switch
4. Factory reset
Please check “Appendix” to
do “Cold Start” and
“Factory Reset”.
Replaced AP
A existing AP was replaced by a new AP
You can reverse AP to the previous configuration or save the current
setting:
Replace: double click to reverse the previous configuration
Save: press the save current status
DHCP error
A AP cannot get IP from the DHCP server
1. Make sure the DHCP server for the AP is available.
2. If the DHCP server did not connect, please reconnect the DHCP server
and wait about 60 seconds, then press the start polling from WLAN
manager
3. If the DHCP server was connected, you can try any one of following
methods:
a. Cold start the AP from the switch webpage and Restart Shutdown the
POE from switch.
b. Cold start by the reconnected AP.
c. Factory reset.
d. Restart the port from web.
Please check “Appendix” to
do “Cold Start” and
“Factory Reset”.
Anti rogue key error
The Anti Rouge AP function of switch was enabled, but the key of AP and
switch is not matched
The AP key is different with connected switch, to active the system key
manager Solution, you can try any one of following methods: