User Manual Part 2

D-Link Smart WLAN Manager User Manual
D-Link Corporation 36
1. Select the all managed system key Error Device
2. All managed device change to same system key
3. Disable the anti rouge function from switch
4. Factory reset the AP and switch
Not available
WLAN Manager can discover AP successfully but cannot get
configuration from AP correctly.
Possible problems:
1. Password error; Delete the troubled AP and run discovery wizard to find
the AP again, make sure the password is correct before discover the AP.
2. Different subnet; change the management PC subnet and to,
a. Try to cold start the AP by web, or
b. Try to factory reset
Unknown device
Unknown network devices
Switch on line
The DES-1228P switch links and works properly in the network.
Switch offline
The existing DES-1228P lost the connection
1. Check the switch power,
2. Check SNMP community and cable and subnet
3. factory reset the switch
New Switch
A new DES-1228P switch was discovered by WLAN Manager.
Group apply AP
The AP setting is same with group setting
Group not apply
The AP setting is different with group setting
Note: If the discover utility can’t find any switch or AP, please ensure there is only one NIC(network interface card) in your PC,
multiple NIC may make the system work abnormally.
Utilization
In Utilization, user can monitor four different statistics by graphic reports.