User's Manual
44D-Link DWR-925 User Manual
Section 3 - Conguration
VPN Dynamic IP
Enter a name for your VPN.
Enter the local (LAN) subnet and mask.
(ex. 192.168.0.0/24)
Enter the amount of time in seconds that the Phase 1 and Phase
2 keys should last.
Choose either ESP, AH or ESP + AH from the drop-down menu.
Enable or Disable the PFS Group option using the drop-down
menu. PFS is an additional security protocol.
Manually enter an ASCII passphrase in the box.
Choose from Username, FQDN, User@FQDN, or Key ID using
the drop-down menu and then the ID in the box.
Choose from Username, FQDN, User@FQDN, or Key ID using
the drop-down menu and then the ID in the box.
Tick this box to enable Dead Peer Detection, then enter the time
in seconds after which a peer is determined to be no longer
active. You may also enter a delay period in seconds.
Tick this box to include additional username and password
authentication requirements for the VPN. Select Server or None.
Then enter the user name and password if required by the remote
VPN server endpoint congured in xAuth Server Mode.
Tick this box to enable IKE Proposal.
Tick this box to enable IPSec Proposal.
Tunnel Name:
Local Subnet/Netmask:
Phase1/2 Key Life Time:
Encapsulation Protocol:
PFS Group:
Preshare Key:
Remote ID:
Local ID:
Dead Peer Detection
(DPD):
XAUTH:
Set IKE Proposal:
Set IPSEC Proposal: