User manual

20
- IR Correction
You can enable or disable the IR (Infra-Red) correction to support IR light or not. Zoom and focus trace data will be
switched according to IR correction ON/OFF. We will only support 850nm IR light source.
The IR correction can be enabled on night (IR-pass) filter.
17. 3DNR Control
3D-DNR removes image noise. If the scenes are not
clear due to low brightness, the function can make
the image clean and obvious.
▶ On / Low / Middle / High
18. STABILIZ ON/OFF
There is some tremble as zoom magnification is high, the function
can compensate the tremble.
▶ On / Off
19. PRESET SET & RUN PAGE
It is a function to set and operate Preset, Group, Tour.
User can see the screen when moves the joystick to Right/Left after
fixing the cursor on the menu.
<<PRESET SETUP PAGE>>
① Preset set CH :User can set Preset No. and title on this menu.
- Preset No. set : Set it by moving the joystick to Right/Left
- Preset title set : User can see the menu “SET ID” when press F/F
key after setting Preset No
◄◄ CAMERA SETUP p3 ►►
18.STABILIZ On/Off : Off
19. Preset Set & Run Page
20.Trace Set Page
21. Alarm CH On/Off Page
22. Alarm Preset Set Page
23. Privacy Zone Set Page
- PREV MENU PAGE
- NEXT MENU PAGE
◄◄ CAMERA SETUP p2 ►►
10. Back Light : Off
11. Set Back Light Mode
12. White Balance : Auto
13. Focus Mode :Oneshot
14. Zoom Max Limit : 28/37
15. DSS Control : 8 Fields
16. Day&Night : Auto
17. 3DNR Control :Middle
- PREV MENU PAGE
- NEXT MENU PAGE
◄◄ CAMERA SETUP p3 ►►
18.STABILIZ On/Off : Off
19. Preset Set & Run Page
20.Trace Set Page
21. Alarm CH On/Off Page
22. Alarm Preset Set Page
23. Privacy Zone Set Page
- PREV MENU PAGE
- NEXT MENU PAGE