User's Manual

4. Search for the RX4 on your Bluetooth® Mobile or Bluetooth® Audio
transmitter. Pair the RX4 with your device and enter the pairing code
„0000".
5. Both devices should now find each other and pair. The LED on the
RX4 flashes slowly after successful pairing.
6. The LED of the RX4 will turn blue, when both devices are connected.
Note: Some Handsets need to be connected after pairing
and require authorisation. Please follow your handset's
manual for these additional steps.
Playing music
1. Connect the RX4 with the delivered audio connection wires with your
home or car entertainment equipment or any speaker system.
2. Make sure the transmitter (mobile phone or any
A2DP Bluetooth®
source) is turned on and paired with RX4 within20 Meters.
3. The blue LED from the B-Speech® RX4 indicates that a Bluetooth®
connection exists by flashing slowly.
4. Send the music from your Bluetooth® source to the B-Speech® RX4
If the connection disappears, the sound is disrupted or breaks down:
Move the transmitter nearer to the RX4.
If the connection does not automatically follow, start the pairing process
again.
Please note:
1. If for any reason the B-Speech® RX4 does not play any music, it
should be restarted. To reset the B-Speech® RX4, repeat the paring
process as described above.
2. Normally, the connection between the transmitter and the receiver is
established once the pairing process is done.
The connection can break for the following reasons:
Technical data:
• 3.5mm audio Jack, swivel up to 270 Deg.
• 170mAh Rechargeable Li-polymer battery, up to 10 hours
operation time
Registration and Safety
Certifi cation/General Information
We hereby declare, that this device carries the CE mark in accordance with the
regulations and standards.
It conforms with the fundamental requirements of the R&TTE- (1995/5/EC), EMC
directive 2004/108/EC as well as the Low Voltage Directive 2006/95/EC.
You can fi nd the complete declaration of conformity under www.b-speech.com.
Note on environmental protection:
After the implementation of the European Directive 2002/96/ EU in the
national legal system, the following applies: Electrical and electronic devices
may not be disposed of with domestic waste. Consumers are obliged by law
to return electrical and electronic devices at the end of their service lives to
the public collecting points set up for this
purpose or point of sale. Details of this are de fined by the national law of the respective
country. This symbol on the product, the instruction manual or the package indicates
that a product is subject to these regulations. By recycling, re-using the materials or
other forms of utilising old devices, you are making an important contribution to
protecting our environment.
FCC Information
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including interference that may cause undesired
operation.
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
Tested to comply with FCC standard. FOR HOME OR OFFICE USE.
Warning :
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. &
This device and its antenna(s) must not be co-located or conjunction with any other antenna or transmitter.